Gustav Dyvling
Mid Sweden
Tel: +46 (0) 790 064 471
The FNC Tacho has a robust mechanical and electrical construction. The difference between a standard encoder and a tachometer is that the tacho is only used to give out speed information into an application. FNC Tacho gives an analog value (Volt or Ampere) depending on how fast the shaft on the front of the encoder rotates. With its Ø50mm outer diameter it can offer both shaft and end hollow shaft between 6 to 12mm and can give protection up to IP67. 0-10V voltage or 4-20mA current output.
Technical data
| Electrical ratings | |
| Voltage supply | 10-30 VDC |
| Protection | Output short circuit protection
Reverse polarity protection |
| Consumption w/o load | 60 mA (24 VDC) |
| Output signals | 0-10 VDC Voltage output
0-5 VDC Voltage output 4-20 mA current output |
| Resolution | Up to 6000 rpm |
| Interference immunity | DIN EN 61000-6-2 |
| Emitted interference | DIN EN 61000-6-4 |
| Approval | CE |
| Mechanical design | |
| Dimensions (flange) | Ø58 mm |
| Shaft loading | 140 N axial
240 N radial |
| Protection DIN EN 60529 | IP54, IP65 |
| Operating speed | 10000 rpm |
| Starting torque | 0.025 Nm (IP 67) |
| Materials | Housing: Aluminium
Flange: Aluminium Shaft: Stainless steel |
| Shaft/Hollow shaft diameter | 6, 8, 10, 12 mm
(other diameters on request) |
| Bearings lifetime | 2x10 rev. at 100% of full rated shaft load (minimum) |
| Operating temperatur | -20…+85 °C |
| Storage temperature | -30 °C up to +90 °C |
| Weight approx | 250 g |
Dimensions
Part number code
